Hero_Tablet-Mobile_210-2-screw-in cylinder with-spring-retention-double-wiper

210-2 Screw-in cylinder, with spring return single-acting, pmax. 400 bar

These screw-in cylinders are used as space-saving clamping cylinders and are characterized, among other things, by their compact design. Thanks to the internal stroke limiter, the cylinder can also be operated without a counter clamping surface.

Download data sheet

Installation instructions:
The screw-in cylinder operates hydraulically, single-acting. It is reset via an integrated spring. The pressure oil is supplied via drilled channels. The cylinder is sealed against the base of the screw-in bore by a sealing ring. Due to the plunger design, ventilation of the rod chamber is unnecessary.

Important notes:
The cylinder can be loaded up to the maximum clamping force in the relaxed and retracted state.
maximum clamping force. Protect the cylinders from direct exposure to aggressive cutting fluids and coolants. General operating conditions and other information can be found in the catalog on the "Recommendations & parameters" page.

Space-saving installation options
Can be used without counter clamping surface
Fully loadable even when retracted
Sealing for low leakage
Ventilation connection unnecessary
Variety through different designs
With crowned piston surface
Available with or without double wipers

Operating pressure:	pmax. 400 bar
Mode of operation:	single-acting
Piston Ø	12, 16, 20, 25 and 32 mm
Stroke:	10, 12, 15, 16 and 20mm
Thrust:	from 1.1 kN at 100 bar to 32 kN at 400 bar
Restoring force	from 30 N to 200 N
Oil connection:	drilled channels
Wiper:	without or with double wiper
Seal type	NBR -10°C to +80°C, FKM up to 150°