Hero_Tablet-Mobile_230-1-deep clamping block cylinder

230-1 Low-block clamping cylinder
 hydraulic, with spring return, single-acting, pmax. 500 bar

Low-block clamping cylinders are used when the clamping force is to be applied to the side of the workpiece.

Configure now Download data sheet

Info

The design means that a horizontal (Fh) and a vertical (Fv) force component are created when the force is applied, the size of which depends on the stroke. The vertical (Fv) force component can amount to a maximum of approx. 25% of the clamping force (Fsp). This force is used to press the workpiece against the support. The horizontal force (Fh) decreases depending on the stroke to at least 95% of the initial force. Alternatively, the pressure oil can be supplied via a G1/4 connection thread or O-ring flange connection.
The clamping piston has an internal stroke limiter. The piston and the pressure piece are each returned to the home position by a spring after pressure relief. Care must be taken to ensure that no cutting or cooling fluids can enter the cylinder.

Special features:

  • transfers the clamping force laterally into the workpiece
  • Wide range of installation options
  • Chip protection thanks to integrated metal scraper
  • Standard cylinders and special variants available
  • Also available with pneumatic position control!
Operating pressure: pmax. 500 bar
Operating principle: single-acting with spring return
Piston Ø: 16, 25 and 36 mm
Stroke 8 and 10 mm
Clamping force:
from 1.7 kN at 100 bar to 40 kN at 500 bar
Stroke limitation: Internal
Oil connection: G1/4 thread or O-ring flange
Seal type: NBR -10°C to +80°C
Wiper: Metal wiper

Configurator

Request now

Get started now and make a personal appointment!

We will be happy to advise you by telephone:
+49 (0) 6401 - 225 999-0

Or make an appointment with us.
Contact us